This is a good starting point, but can fine tune these to any value or increment desired from 1 to 64. Using the settings below spreads the range from 24 > 64 in increments of 5. The lowest factory levels were 14 > 22, and the highest were 40 > 48. PowerOn while holding '3' button displays firmware on UV5R.

UV5R series radios with firmware BFB291 and later. The CHIRP Service Settings will adjust the levels on: Testing that has been done indicates the following:

There are too many Baofeng/Pofung models, variants, and firmware versions to be certain which radios are compatible and which ones aren't. A new 'Service Settings' tab has been added to CHIRP which allows you to alter the factory level settings, so a weak signal can open level 1, and only a monster signal can open level 9.Īt this time we are not aware of any measurements made with actual test equipment that is designed to measure actual squelch sensitivity, but on the air testing confirms that it definitely works. Through the efforts of Jim KC9HI and the CHIRP development team, this has become a thing of the past. Until now, it was one of those little 'quirks' you just needed to tolerate.īut no longer. The smallest noise burst would easily pop open the squelch. The factory squelch settings on these models has long been known to have little or no impact on the actual squelch level. This is not compatible with UVB5/B6 or BF888S models Modifying settings will change the way your Here is the overview from Miklor of the squelch settings: I'm really excited to test this with the BF-F8HP that BaofengTech has provided. You may have seen it elsewhere, but CHIRP now has ability to modify the squelch levels for some Baofeng radios.

Programming software for baofeng bf888s